====== Extruder handle is too tight - Tina2 ======

1. Use a 2mm wrench to slightly loosen the screws on the extruder handle.
{{ :tina2:058.png?direct&400 |}}
\\
\\
\\
====== Extruder gear is loose - Tina2 ======

1.Use a 2mm wrench to loosen the screw on the extruder handle and remove the handle. 
{{  :tina2:050.png?direct&800  }}
2.Use a 2mm wrench to loosen the 3 screws on the extruder and remove the entire extruder. 
{{  :tina2:051.png?direct&400  }}
3.Use a 1.5mm wrench to tighten the set screw. 
{{  :tina2:052.png?direct&800  }}
4.Reattach the extruder and tighten the screws. 
{{  :tina2:053.png?direct&400  }}
5.After reattaching the handle, tighten the screws. 
{{  :tina2:054.png?direct&800  }}
\\