====== Replace fan - Tina2s V10 ======
\\
\\
\\
Perform the "Load filament" and wait until the nozzle temperature is higher than 50℃, then check whether the fan is rotating. If it does not rotate, it is a fan failure and needs to be replaced.\\
{{ :tina2:06.png?direct&400 |}}{{ :tina2:021.png?direct&400 |}}
\\
====== Replace fan - Tina2s V10 ======
\\
1.Loosen this screw with a 2mm L-wrench and open the cover.
{{ :tina2:035.png?direct&800 |}}
2.Loosen these 4 screws with a 2.5mm L-wrench.
{{ :tina2:036.png?direct&800 |}}
{{ :tina2:027.png?direct&400 |}}
3.unplug this connector, and remove the fan.
{{ :tina2:037.png?direct&800 |}}
4.Install the new fan, ensuring that this label faces inwards.
{{ :tina2:038.png?direct&800 |}}
5.Plug in the connector.
{{ :tina2:028.png?direct&400 |}}
6.Use the 4 screws to reinstall the entire assembly, and tighten the screws.
{{ :tina2:039.png?direct&800 |}}
{{ :tina2:034.png?direct&400 |}}