====== The filament is stuck in the extruder or tube ======

===== The filament is stuck in the extruder ===== {{ :tina2:01.png?direct&400 |}} \\ 1. Cut the filament into a bevel and insert it into the extruder. \\ {{ :tina2:图片15.png?nolink&800 }}\\ \\ \\ ===== The filament tube is not inserted all the way; the filament is stuck between the tube and the extruder ===== {{ :tina2:01.png?direct&400 }}\\ 1. Pull back the filament.\\ {{ :03.jpg?direct&400 }}2.Press both ends of the Tube Fitting to remove the filament tube.\\ {{ :tina2:04.jpg?direct&400 }}3. Check if the end of the filament tube is flat; if not, trim off the uneven part of the tube, ensuring a vertical cut.\\ {{ :tina2:05.jpg?direct&400 }}{{ :tina2:图片16.png?nolink&400 }}4. Reinsert the material tube fully at the bottom，about 2 cm.\\ {{ :tina2:05.jpg?direct&400 }}5. Reinsert the filament, push it all the way down, and restart the feeding process.\\ {{ :tina2:06.png?direct&200 }} ===== The filament is stuck in the tube ===== {{ :tina2:02.png?direct&400 |}} 1. Pull back the filament.\\ {{ :03.jpg?direct&400 |}} 2.Press both ends of the Tube Fitting to remove the filament tube.\\ {{ :tina2:04.jpg?direct&400 |}} 3. If there are impurities inside the tube, cut off this section of the tube.\\ {{ :tina2:图片16.png?nolink&400 }}\\ 4. Reinsert the material tube fully at the bottom，about 2 cm. {{ :tina2:05.jpg?direct&400 |}} 5. Reinsert the filament, push it all the way down, and restart the feeding process. {{ :tina2:06.png?direct&200 |}} \\ \\ \\ \\ ====== Change the filament tube ====== 1.Press both ends of the Tube Fitting to remove the filament tube. {{ :tina2:09.png?direct&400 |}} 2.Press both ends of the Tube Fitting, and remove the tube of extruder. {{ :tina2:04.jpg?direct&400 |}} 3.Replace with a new tube and insert it into the extruder. Make sure to push it in all the way, approximately 2 cm. {{ :tina2:063.png?direct&400 |}}{{ :tina2:05.jpg?direct&400 |}} 4.Reinsert the tube into the bottom of nozzle; approximately 6cm deep. Ensure it is fully inserted to avoid future blockages. {{ :tina2:012.png?direct&800 |}}