PoloPrint Wiki
Docs ยป starry:cleanyrubberwheel

Clean Y rubber wheel

When to maintain

The Y rubber wheel will be loose and wear during the operation of the machine. If the Y rubber wheel on the platform does not move freely when moving back and forth, it will lead to the dislocation of the model. The technician recommends maintaining the Y rubber wheel monthly. If the Y rubber wheel is found to be worn, the new Y rubber wheel should be replaced in time. Avoid affecting the printing.

How to maintain

Brush the Y rubber wheel to clean the foreign matter on the Y rubber wheel (graph 24)

                                                    graph 24

Apply silicone grease to increase lubrication (graph 25)

                                                    graph 25

If the Y rubber wheel is found to be worn, the new Y rubber wheel should be replaced in time. Avoid affecting the printing.

Previous Next

PoloPrint Wiki

Table of Contents

Home

Starry Serials

  • Introduce
  • Unpacking Guide
  • User Manual
  • Wifi Config
  • Slicing Software
  • Maintenance
    • Clean the nozzle
    • Clean X-axis horizontal bar
    • Clean Z-axis silk rod
    • Clean Spray head fan
    • Clean X leather belt
    • Clean Y leather belt
    • Clean X rubber wheel
    • Clean Y rubber wheel
    • Replace the nozzle
    • Replace the proximity switch
    • Replace the fan
    • Replace the X travel switch
    • Replace the Y travel switch
    • Replace the Z travel switch
    • Replace the extruder assembly
    • Replace X motor
    • Replace Y motor
    • Replace Z motor
    • Replace the broken wire detection module
    • Replace the light strip board
    • Replace X belt
    • Replace Y belt
    • Replace Y rubber wheel
    • Replace X rubber wheel
    • Change the motherboard
    • Replace the chassis fan
    • Replace the power
    • Replace the hot bed
    • Clean Spray head fan
    • Replace the 20P line
    • Firmware upgrade
  • FAQ