PoloPrint Wiki
Docs ยป starry:replacetheztravelswitch

Replace the Z travel switch

operating steps

Turn off the machine (graph 110)

                                         graph 110

Disconnect the Z limit switch interface on the upper right of the machine and indicate Z on the line (graph 111)

                                         graph 111

Remove retaining screw (graph 112,113)

                                         graph 112

                                         graph 113

Remove the rod retaining block (graph 114)

                                         graph 114

Remove the fixing screw of the Z-travel switch (Fig. 115,116)

                                         graph 115

                                         graph 116

Replace the new Z travel switch (graph 117)

                                         graph 117

Install the fixing Z travel switch fixing screw (Fig. 118,119)

                                         graph 118

                                         graph 119

Install the wire rod fixing block (Fig. 120,121)

                                         graph 120

                                         graph 121

Connect the Z travel switch line interface (Fig. 122) and recalibrate the platform (Fig. 122-1)

                                         graph 122

                                         graph 122-1
Previous Next

PoloPrint Wiki

Table of Contents

Home

Starry Serials

  • Introduce
  • Unpacking Guide
  • User Manual
  • Wifi Config
  • Slicing Software
  • Maintenance
    • Clean the nozzle
    • Clean X-axis horizontal bar
    • Clean Z-axis silk rod
    • Clean Spray head fan
    • Clean X leather belt
    • Clean Y leather belt
    • Clean X rubber wheel
    • Clean Y rubber wheel
    • Replace the nozzle
    • Replace the proximity switch
    • Replace the fan
    • Replace the X travel switch
    • Replace the Y travel switch
    • Replace the Z travel switch
    • Replace the extruder assembly
    • Replace X motor
    • Replace Y motor
    • Replace Z motor
    • Replace the broken wire detection module
    • Replace the light strip board
    • Replace X belt
    • Replace Y belt
    • Replace Y rubber wheel
    • Replace X rubber wheel
    • Change the motherboard
    • Replace the chassis fan
    • Replace the power
    • Replace the hot bed
    • Clean Spray head fan
    • Replace the 20P line
    • Firmware upgrade
  • FAQ